Mitsubishi Electronics TG-2000A User Manual download pdf (Page 17)

6.2 Basic Mouse Operation

First, use of the mouse as a pointing device will be explained. If a device other than a mouse is being

used, consult with the manual for that device.

The following is a list of terms used in describing mouse operations.

Click : This refers to pressing and releasing the button one time.

To use this function, click the button

Double Click: This refers to pressing and releasing the button twice in quick succession.

Drag : This refers to moving the mouse pointer on top of an object on the screen, pressing

and holding down the button to select the object, then, while holding the button down,

moving the mouse pointer, and the object, to a different location.

Keyboard : Primarily used when entering password, characters, or numerics.

6.3 Accessing Functions and M oving between Windows

The functions of the TG-2000A can be divided into two general categories.

1) Functions that monitor air conditioner operation status and control functions……Initial window

2) Operation and system initialization and charge data maintenance functions (functions used to

accomplish functions in 1) above)……Control window(Management screen)

This section deals mostly with functions in category 2).

(1) Shift from the initial window to the control window

The following shows the procedure to shift from the initial window to the control window. Shift the

screen to the control window after completing the initial setting shown in Chapter 8.

[Procedure]

1) Select [Finish] button.

Click the [Finish] button located on the lower right on

the initial screen. With the above step, the

confirmation screen (asking whether or not to trans-

mit the setting contents to the G-50A) is displayed.

2) Select [OK] button.

Click the [OK] button to transmit the initial setting

contents to the G-50A.

The start-up display screen is displayed after the

screen has been shifted to the control window. The

system information set or changed is transmitted to

each G-50A to enter upon the start-up processing.

It takes approximately 10 to 20 minutes to start-up.

* Note that the setting contents will not be trans-

mitted to the G-50A when the [Cancel] button is

clicked. If it is used when only the maintenance

group function is operated, it is possible to shorten

the time required until the control window

resumes.

(2) Shift from the control window to the initial

window

The control window shifts to the initial window when

the initial setting contents are changed or when the

charge calculation maintenance is performed.

[Procedure]

1) Select [Configuration] and then [System set] in the

menu bar.

Click the [Configuration] in the menu bar on the

control window to select the [System set]. The

password confirmation screen is displayed.

Screen of confirmation for

transmitting set contents

Start-up display screen

Display screen of Shift to setting screen

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 97 98

Comments to this Manuals

No comments

Mitsubishi Electronics TG-2000A User Manual Page 17

Comments to this Manuals

Related products and manuals for Split-system air conditioners Mitsubishi Electronics TG-2000A