Mitsubishi Electronics SW1DNC-GXW2-E User Manual download pdf (Page 86)

4 - 10

4.4.2 Batch monitoring of device values

4 CREATING PROGRAM IN ST LANGUAGE

GX Works2

4.4.2 Batch monitoring of device values

For the Batch monitoring of device values procedure, refer to the following.

3.4.2 Batch monitoring of device values

5. Turn ON inputs X0, X1 and X2 in the programmable controller, and check the following

operations.

You can turn ON inputs X0, X1 and X2 using the test operation above.

• When X0 turns ON, the programmable controller turns ON Y10, and then turns OFF Y10 1

second later.

• When X1 turns ON, the programmable controller transfers K10 to VAR1 (device: D0).

• When X2 turns ON, the programmable controller transfers K20 to VAR1 (device: D0).

6. Select [Online] [Monitor] [Stop

Monitoring] to stop (pause) the monitor status

on the POU_01 [PRG] Program [ST] screen.

You can click (Stop Monitoring) to reset the

POU_01 [PRG] Program [ST] screen.

7. Set the programmable controller CPU to STOP.

Set the RUN/STOP switch on the programmable

controller CPU to "STOP".

You can switch the programmable controller status

between "RUN" and "STOP" using remote

operation.

"Point" in the step4

Y10 remains ON

for 1 second.

X0 turns ON.

VAR1 becomes "10".

X1 turns ON.

VAR1 becomes "20".

X2 turns ON.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 109 110

No comments

Mitsubishi Electronics SW1DNC-GXW2-E User Manual Page 86