Mitsubishi Electronics Mitsubishi Digital Electronics Home Theater System 838 User Manual download pdf (Page 7)

1. Basic Setup and Operation 7

For assistance call 1(800) 332-2119

The STATUS Indicator

Key Off Steady On

Slow Blinking Fast Blinking

LED Color TV Condition

None

TV is powered off. Normal operation.

Green

TV is powered on. Normal operation.

Green

TV powered off, auto-on TV Timer is

set.

Normal operation. TV can be turned on

at any time.

Green

TV just powered off and lamp is

cooling.

Sixty seconds after turning off TV, LED

will start to blink. TV can be turned back

on before blinking starts or after blink-

ing stops, but not while the indicator is

blinking. Normal operation.

Yellow

TV is too hot.

The TV will display a

warning message and shut off if it over-

heats.

• Ambientroomtemperaturemaybe

too high. Turn off the TV and let the

room temperature drop.

• Clearblockedairvents.Ensureat

least a four-inch clearance on all

sides of the TV.

Yellow

Lamp access door is not secure or no

lamp installed.

TV will not operate until lamp access

door is secured. See Appendix A.

Red

Lamp failure. Replace the lamp. See

Appendix A.

Red/

Yellow

TV may require service.

Hold power button on front panel for •

10 seconds to reset TV.

If LED continues to flash red and •

yellow after reset, turn off the TV and

unplug it from the AC power source.

Wait one minute and then plug the

set back in.

If LED continues to flash red and •

yellow,

go to www.mitsubishi-tv.com

or call 1-800-332-2119 to receive

Authorized Service Center informa-

tion.

You may be asked to count how

many times the LED flashes each

color to aid in troubleshooting.

Using the ANT (Antenna) Input

If using an antenna or direct cable service (no cable

box), connect the incoming coaxial cable to the TV’s

ANT

input. Refer to page 12.

You must perform a channel scan to enable recep-

tion of digital channels. If you skip this step, the TV

will receive only analog channels. The channel scan

will search for high-definition and standard-definition

channels available in the local area.

Memorizing Channels with Channel Scan

For the ANT input

To start channel memorization

Power on the TV.

Press

and open the Setup > Channel menu.

First press to navigate to the Setup icon, then

use to highlight the Channel icon.

Start channel memorization from the Setup > Channel

menu.

Press

to enter the menu.

Highlight

Ant Air if connected to an

over-the-air antenna. Highlight Ant

Cable for service over direct cable

(no cable box). Press

ENTER

to add a

check.

For first-time setup, highlight

All

channels. To scan for channels not

already in memory, highlight New

only. Press

ENTER

to add a check.

Highlight

Scan and press

ENTER

Channel memorization may take up

to 15 minutes to complete.

To stop channel memorization before completion,

press

CANCEL

Setting Up and Using TV Inputs

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Comments to this Manuals

No comments

Mitsubishi Electronics Mitsubishi Digital Electronics Home Theater System 838 User Manual Page 7

Comments to this Manuals