Mitsubishi Electronics P91DW User Manual download pdf (Page 22)

When the thermal head is dirty with dust and perspiration, etc., white spots or stripes may

appear on the print. In this case, clean the thermal head in the following procedure BY

USING THE SUPPLIED CLEANING PAPER.

Roll the cleaning

paper and install

into the set.

Switch the left side

lever to the "OPEN"

position.

Press the "POWER"

switch to turn on the

power.

Adjust the red mark

on the cleaning

paper parallel to the

platen roller.

Cleaning paper

Platen roller

Red mark

Keep pressing the

"FEED" button until

you hear a beep.

Open the door.

Take out the

cleaning paper.

Do not pull out the

cleaning paper while

the door is closed.

Close the door

without taking out

the cleaning paper.

Repeat the steps - by 2 or 3 times,

and print 1-2 sheets to verify the

cleaning effect.

Close the door.

Press the "FEED" button.

Take out the cleaning paper.

Turn on the power.

CAUTION

It is recommended that after printing 10 rolls of paper the unit be cleaned using the supplied cleaning paper.

If the symptom of the dirty head is not corrected even after cleaning, your set needs repairing, contact your dealer.

Do not pull out the sheet and the cleaning paper while the door is closed.

This may cause extensive damage on the unit.

Never use other cleaning papers. It may cause damage to the thermal head.

This cleaning paper should be used only for cleaning the thermal head. Do not use it for other purpose.

Insert the cleaning paper.

Open the door.

USE OF CLEANING PAPER

FEED

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Mitsubishi Electronics P91DW User Manual Page 22

Comments to this Manuals

Related products and manuals for Print & Scan Mitsubishi Electronics P91DW