Mitsubishi Electronics SW1DNC-GXW2-E User Manual download pdf (Page 42)

3 - 14

3.2.6 Creating a program

3 CREATING PROGRAM IN STRUCTURED LADDER/FBD LANGUAGE

GX Works2

7. Click (Close contact) on the Structured

Ladder/FBD toolbar, and then move the cursor

to a desired position to display a close contact

there.

Click the close contact to connect it with a

function of the LDP and enable setting of a

variable.

Settings

• Variable: TS0

*1: "TS0" indicates a contact of the timer T0.

8. Draw a grid line on the left figure (position 1)

using the procedure described in the step 3.

After drawing grid lines, click (Select Mode) on

the Structured Ladder/FBD toolbar to specify the

Select mode.

9. Click (Coil) on the Structured Ladder/FBD

toolbar, and then move the cursor to a desired

position to display a coil there.

Click the coil to connect it with the close contact

"TS0" and enable setting of a variable.

After drawing grid lines, click (Select Mode) on

the Structured Ladder/FBD toolbar to specify the

Select mode.

Settings

• Variable: Y10

10.Select "Function" "OUT_T" on the Function

Block Selection window, drag it, and drop it in a

desired position to position "OUT_T" there.

Click "?" of "TCoil

" and "TValue

", and set the

input variables.

Settings

• TCoil : TC0

•TValue: 10

*1: Set a coil of the timer to "TCoil".

*2: Set the set value of the timer to "TValue".

*3: "TC0" indicates a coil of the timer T0.

Input variables

TCoil and TValue

(To the next page)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 109 110

Comments to this Manuals

No comments

Mitsubishi Electronics SW1DNC-GXW2-E User Manual Page 42

Comments to this Manuals