Mitsubishi Electronics M557 User Manual download pdf (Page 10)

English-6

Quick Start

To attach the monitor to your system, follow these

instruction:

1. Turn off the power to your computer and the monitor.

2. If necessary, install the display card. For more information, refer to

the display card manual.

3. For the PC: Connect the 15-pin mini D-SUB of the captive signal

cable to the connector of the display card in your system (Figure A.1)

Tighten all screws.

For the Mac: Connect the Macintosh Cable Adapter (not included) to

the monitor connector on the Macintosh (Figure B.1). Attach the

15-pin mini D-SUB end of the captive signal cable to the Macintosh

cable adapter on the computer (Figure B.1). Tighten all screws.

4. Connect one end of the power cord to the monitor and the other end

to the power outlet (Figure C.1).

5. Turn on the monitor (Figure D.1) and the computer.

6. This completes the installation.

NOTE: If you have any problems, please refer to the

Troubleshooting section of this User‘s Manual.

Captive Signal Cable

15-pin-mini-D-SUB

Figure A.1

01_english 24/5/01, 3:23 pm6

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 115 116

No comments

Mitsubishi Electronics M557 User Manual Page 10